beautypg.com

4 reinstalling the raid controller, Section 2.3.5.4, reinstalling the raid controller – Avago Technologies Cache Protection for RAID Controller Cards User Manual

Page 35

background image

Avago Technologies

- 35 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015

Chapter 2: Installing the Cache Backup Products

Installing the LSIiBBU06 Unit

2.3.5.4

Reinstalling the RAID Controller

Follow these steps to install the controller in the computer.

1.

With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.

2.

Insert the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.

NOTE

This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; a
controller installed in one of these slots will not function. Refer to the
guide for your motherboard for information about the PCIe slot.

3.

Press down gently, but firmly, to seat the card correctly in the slot.

Figure 19 Reinstalling the RAID Controller

4.

Secure the controller to the computer chassis with the bracket screw.

5.

Attach the cables from the internal port connectors to the drives.

6.

Replace the computer cover, and reattach the power cords.

7.

Turn on the power to the computer.

NOTE

Refer to the MegaRAID SAS Software User Guide for information on
running the RAID configuration utility and the MegaRAID SAS Device
Driver Installation User Guide
for information on installing the drivers.

Edge of Motherboard

Screw

Press

Here

Press

Here

3_00777-00