Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 96)

Avago Technologies
- 96 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Attaching the CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
5. Reinstall the computer cover, and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the
MegaRAID SAS Device Driver Installation User Guide for information on installing the software drivers.
2.10 Attaching the CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller
and Connecting to a Remote CVPM02 Module
This section describes how to attach the CVFM03 module to the MegaRAID SAS 9265CV-8i RAID controller, and then
connect the CVFM03 module to a remote CVPM02 module.
2.10.1 Top View and Bottom View of the CVFM03 Module
The following figure shows the top view and the bottom view of the CVFM03 module. The top view is the side that
you can see when the unit is installed on a RAID controller.
Figure 65 Top View and Bottom View of the CVFM03 Module
NOTE Record your controller serial number in a safe location, in case you
need to contact Avago.
Top View
Bottom View
J2A1
Connector
J2M1
Connector
3_00917-00