Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 91)

Avago Technologies
- 91 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Connecting a CVFM02 Module on a RAID Controller to a CVPM02 Module Mounted on a
Remote Mount Board
2.9.2 Installing the Clip on the Remote Mount Board
Follow these steps to install the clip directly on the BBU-BRACKET-05 remote mount board.
1. With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the system
is grounded.
2. Remove the clip and the remote mount board module from the package.
3. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
4. Hold the clip so that the screw holes on the clip line up with the screw holes on the remote mount board, as
shown in the following figure.
Figure 60 Installing the Clip on the Remote Mount Board
5. Secure the clip to the remote mount board in three screw holes with the screws and the nuts.
6. The screws thread through the front of the clip and the remote mount board.
NOTE Center the screwdriver carefully to avoid stripping the screw heads.
Do not overtighten the screws.
A
A
A
Clip
3_00895b-00