beautypg.com

Section 2.5.2.2, installing the lsiibbu08, Unit directly on a raid controller, J6b1 – Avago Technologies Cache Protection for RAID Controller Cards User Manual

Page 61

background image

Avago Technologies

- 61 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015

Chapter 2: Installing the Cache Backup Products

Installing the LSIiBBU08 Unit

2.5.2.2

Installing the LSIiBBU08 Unit Directly on a RAID Controller

Follow these steps to install the LSIiBBU08 unit on the front of the MegaRAID SAS 9280-8e RAID controller.

WARNING

If you replace the battery incorrectly, it could explode. Replace the
battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.

1.

Ground yourself, and make sure that the system is grounded.

2.

Remove the LSIiBBU08 unit from the package.

3.

Place the LSIiBBU08 unit front-side-up on a flat, clean, static-free surface.

4.

With the front side up, place the RAID controller on a flat, clean, static-free surface.

5.

Hold the LSIiBBU08 unit so that the battery side is facing upward and the J1 connector lines up with the J6B1 BBU
connector on the MegaRAID SAS 9280-8e RAID controller, as shown in the following figure.

NOTE

Refer to the 6Gb/s MegaRAID SAS RAID Controllers User Guide for the
BBU connectors to use on the other RAID controllers that use the
LSIiBBU08 unit.

Figure 37 Installing the LSIiBBU08 Unit on the MegaRAID SAS 9280-8e RAID Controller

6.

Carefully press the LSIiBBU08 unit onto the RAID controller so that the two connectors are firmly joined.

7.

Secure the LSIiBBU08 unit to the RAID controller with the screws and the standoffs in the three screw holes.

The standoffs are threaded at both ends, and a screw goes into each end. The screw threads from the back of the
controller board into the board-to-board standoffs on the bottom of the LSIiBBU08 unit.

NOTE

Center the screwdriver carefully to avoid stripping the screw heads.
Do not overtighten the screws.

85065-01

J6B1

Model: BA

T1

S1P

WARNING:

The battery

used

in

this

device may

present

a risk

of fire or

chemic

al burn if mistreated.

DO NOT

dissemble, heat above

60C, crus

h or

puncture,

short

circuit external

contac

ts,

or dispos

e in fire or water

.

Con

tain

s:

Son

y U

S45

426

1A

8T

Cell

Rec

har

gea

ble

Li-

Poly

me

r

Batte

ry P

ack

Ratin

g:

3.7

V; 1

.59

Ah; 5

.9W

h

Fin

ishe

d in

C

hin

a

BB

U P

/N

: L4-25

34

3-04

BB

U S

/N

:S

Y027

00

225

SO

Li-ion