Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 103)

Avago Technologies
- 103 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Attaching the CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
2.10.7 Installing the Remote Mount Board in the System
Follow these steps to install the remote mount board in the system.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCI Express slot on the motherboard, as shown in the following figure.
NOTE Some PCI Express slots support only PCI Express graphics cards. If a
RAID controller is installed in one of these slots, the controller will not
function. Refer to your computer documentation for information
about the PCI Express slot.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Use the bracket screw to secure the remote mount board to the computer chassis.
Figure 71 Installing the Remote Mount Board in the System
5. Reinstall the computer cover and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the
MegaRAID SAS Device Driver Installation User Guide for information on installing the software drivers.
3_00918-01
Press
Here
Press
Here
Bracket
Screw
Remote Mount
Board
CacheVault
Flash Module 03
(CVFM03)
CacheVault
Power Module 02
(CVPM02)