beautypg.com

1 removing the raid controller from the computer – Avago Technologies Cache Protection for RAID Controller Cards User Manual

Page 97

background image

Avago Technologies

- 97 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015

Chapter 2: Installing the Cache Backup Products

Attaching the CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and

Connecting to a Remote CVPM02 Module

2.10.2

Installing the CVFM03 Module Directly on the MegaRAID SAS 9265CV-8i RAID Controller

Follow these steps to install the CVFM03 module directly on the LSIiBB05.

1.

Remove the RAID controller from the computer. For this procedure, see

Section 2.10.2.1, Removing the RAID

Controller from the Computer

, on page

97

.

2.

Attach the CVFM03 module directly to the RAID controller. For this procedure, see

Section 2.10.2.2, Attaching the

CVFM03 Module Directly to the RAID Controller

on page

98

.

CAUTION

Electrostatic discharge can damage the CVFM03 module and the
MegaRAID SAS 9265CV-8i RAID controller. Make sure that you install
the CVFM03 module at an ESD-safe workstation that meets the
EIA-625 Standard. When you install the CVFM03 module, follow the
ESD-recommended practices in the latest revision of the IPC-A-610
(Acceptability of Electronic Assemblies) standard.

2.10.2.1

Removing the RAID Controller from the Computer

Follow these steps to remove the RAID controller from the computer.

1.

Turn off the power, and unplug the power cords.

2.

Ground yourself, and make sure that the system is grounded.

3.

Remove the cover from the computer according to the instructions in the system user’s manual to allow access to
the controller.

4.

Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.

5.

Place the controller on a flat, clean, static-free surface, and continue with the next procedure.