4 reinstalling the raid controller, Section 2.3.6.4, reinstalling the raid controller – Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 39

Avago Technologies
- 39 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU06 Unit
2.3.6.4
Reinstalling the RAID Controller
Follow these steps to reinstall the RAID controller in the computer.
1.
With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2.
Insert the RAID controller into a PCI Express slot on the motherboard, as shown in the following figure.
NOTE
This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
However, some PCIe slots support only PCIe graphics cards; a
controller installed in one of these slots will not function. Refer to the
guide for your motherboard for information about the PCIe slot.
3.
Press down gently, but firmly, to seat the controller correctly in the slot.
Figure 22 Reinstalling the RAID Controller
4.
Secure the controller to the computer chassis with the bracket screw.
Edge of Motherboard
Screw
Press
Here
Press
Here
3_00706-00