beautypg.com

4 reinstalling the controller in the host computer – Avago Technologies Cache Protection for RAID Controller Cards User Manual

Page 69

background image

Avago Technologies

- 69 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015

Chapter 2: Installing the Cache Backup Products

Installing the LSIiBBU08 Unit

2.5.5.4

Reinstalling the Controller in the Host Computer

Follow these steps to install the RAID controller in the computer.

1.

With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.

2.

Insert the RAID controller in a PCIe slot on the motherboard, as shown in the following figure.

NOTE

This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
However, some PCIe slots support only PCIe graphics cards; a
controller installed in one of these slots will not function. Refer to the
guide for your motherboard for information about the PCIe slot.

3.

Press down gently, but firmly, to seat the card correctly in the slot.

Figure 43 Reinstalling the RAID Controller

4.

Secure the controller to the computer chassis with the bracket screw.

5.

Replace the computer cover and reattach the power cords.

6.

Turn on the power to the computer.

Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the
MegaRAID SAS Device Driver Installation User Guide for information on installing the software drivers.

Edge of Motherboard

Bracket Screw

Edge of
Motherboard

Press Here

85039-09

Press Here