Unit – Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 68

Avago Technologies
- 68 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU08 Unit
2.5.5.3
Connecting the Cable Between the Interposer Card and the LSIiBBU08 Unit
Follow these steps to connect the cable between the interposer card on the RAID controller and the LSIiBBU08 unit.
1.
Mount the LSIiBBU08 unit to the chassis of your computer based on the location and the type of
mounting option.
2.
With the controller on a flat, clean, static-free surface, ground yourself, and make sure that the system
is grounded.
3.
Remove the cable included in the Remote Battery Kit (sold separately).
4.
Insert one end of the cable into the 20-pin J2 connector on the LSIiBBU08 unit and the other end into the 20-pin
J1 connector on the interposer card, as shown in the following figure.
Align the black triangles on the connectors to make sure that the connectors are connected correctly.
CAUTION
The cable connectors are polarized and can be inserted into the
connectors on the interposer card and the LSIiBBU08 unit only if the
rails on the cable connectors align with the slots on the other
connectors. Do not force the cable into the 20-pin connectors. The
cable end inserts into the connector with minimal resistance.
Figure 42 Connecting the LSIiBBU08 Unit Remotely to the Interposer Card
85039-08