Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 13)

Avago Technologies
- 13 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU01 Unit
Follow these steps to connect the LSIiBBU01 unit remotely to the MegaRAID SAS 8888ELP RAID controller.
1. Ground yourself, and remove the LSIiBBU01 unit from the package.
2. Use the three Phillips-head screws that are provided to secure the LSIiBBU01 unit to the motherboard or
server chassis.
3. Insert the battery pack harness connector at the end of the 5-pin cable into the J2 connector on the back side of
the unit.
4. Connect the 12-in. cable from the J1 connector on the LSIiBBU01 unit to the J10 battery backup connector on the
back of the RAID controller, as shown in the following figure.
Figure 2 Installing the LSIiBBU01 Unit on the MegaRAID SAS 8888ELP RAID Controller