Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 70)

Avago Technologies
- 70 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU08 Unit
2.5.5.5 Installing the Remote Mount Board in the Host Computer
Follow these steps to install the remote mounting board in the computer.
1. With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the remote mounting board in a PCIe slot on the motherboard, as shown in the following figure.
NOTE Some PCIe slots support only PCIe graphics cards; if the remote
mounting board is installed in one of these slots, the board will not
function. Refer to your computer documentation for information
about the PCIe slot.
3. Press down gently, but firmly, to seat the board correctly in the slot.
Figure 44 Installing the Remote Mounting Board
4. Secure the remote mounting board to the computer chassis with the bracket screw.
5. Reinstall the computer cover and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the
MegaRAID SAS Device Drivers Installation User Guide for information on installing the software drivers.
85085-04
LSI 31504-00 Rev
. B
Li- io n
CAUTION: Danger of explos
ion if battery
is incorrec
tly replaced.
Replace
with same
or equivalent
type recommended
by manufacturer
.
Dispos
e of used
batteries
according to manufacturer
’s instruc
tions.
Pb
e1
5
Press
Here
Press
Here
Screw