Section 2.3.5.2, installing – Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 33

Avago Technologies
- 33 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU06 Unit
2.
Remove the cover from the computer, according to the instructions in the system user manual, to allow access to
the controller.
3.
Ground yourself before you touch the controller.
4.
Unplug all cables from the controller, remove the screw attaching the bracket to the computer chassis, and
carefully remove the controller from the slot.
5.
Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
2.3.5.2
Installing the Board-to-Board Adapter Card on the RAID Controller
Follow these steps to install the board-to-board adapter card on the controller, as shown in the following figure.
1.
With the controller on a flat, clean, static-free surface, ground yourself, and remove the adapter card, standoff, and
screws from the package.
2.
Place the standoff on the controller so that the bottom side is positioned over the screw hole next to the
J10 connector on the controller.
3.
Use one of the screws to secure the standoff to the controller.
NOTE
Center the screwdriver carefully to avoid stripping the screw head.
Do not overtighten the screws.
4.
Hold the adapter card so that the J1 board-to-board connector lines up with the J10 board-to-board connector
on the RAID controller.
5.
Carefully press the J1 connector on the adapter card into the J10 connector on the controller so that the two
connectors are joined firmly.
The connectors fit only when they are in the correct alignment.
6.
Use the other screw to secure the adapter card to the controller, and continue with the next procedure.
Figure 17 Connecting the Board-to-Board Adapter Card to the MegaRAID SAS 8708EM2 RAID Controller
3_00719-00
J10