Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 94

Avago Technologies
- 94 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Connecting a CVFM02 Module on a RAID Controller to a CVPM02 Module Mounted on a
Remote Mount Board
2.9.5
Reinstalling the MegaRAID SAS 9266-8i RAID Controller on the Motherboard
Follow these steps to reinstall the CVFM02 module on a motherboard.
1.
With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2.
Install the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.
NOTE
This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; if a
remote mount board is installed in one of these slots, the remote
mount board will not function. Refer to the guide for your
motherboard for information about the PCIe slot.
3.
Press down gently, but firmly, to seat the card correctly in the slot.
4.
Secure the controller to the computer chassis with the bracket screw.
Figure 63 Reinstalling the MegaRAID SAS 9266-8i RAID Controller
Edge of
Motherboard
PCI Express
Bracket
Screw
Press
Here
Press
Here
3_00899-00