Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 80

Avago Technologies
- 80 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU09 Unit
2.6.2.3
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on a motherboard.
1.
Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2.
Install the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.
NOTE
Some PCI Express slots support only PCI Express graphics cards. A RAID
controller installed in one of these slots will not function. Refer to your
computer documentation for information about the PCI Express slot.
3.
Press down gently, but firmly, to seat the card correctly in the slot.
4.
Secure the controller to the computer chassis.
Figure 51 Reinstalling the RAID Controller
5.
Replace the computer cover, and reattach the power cords.
6.
Turn on the power to the computer.
Edge of
Motherboard
PCI Express
Bracket
Screw
Press
Here
Press
Here
3_00891a-00