Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 57)

Avago Technologies
- 57 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU07 Unit
2.4.6.5 Installing the Remote Mount Board
Follow these steps to install the remote mount board in the host computer.
1. With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCIe slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the board correctly in the slot.
Figure 35 Installing the Remote Mount Board
4. Secure the remote mount board to the computer chassis with the bracket screw.
5. Attach the cables from the external port connectors to the drives.
6. Reinstall the computer cover, and reattach the power cords.
7. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the
MegaRAID SAS Device Driver Installation User Guide for information on installing the software drivers.
Screw
Press
Here
Press
Here
3_00722-00