beautypg.com

1 top view and bottom view of the rcm01 module, Host computer – Avago Technologies Cache Protection for RAID Controller Cards User Manual

Page 82

background image

Avago Technologies

- 82 -

Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015

Chapter 2: Installing the Cache Backup Products

Installing the LSIiBBU09 Unit

2.6.3.1

Top View and Bottom View of the RCM01 Module

The following figure shows the top view and the bottom view of the RCM01 module. (The top view is the side that you
can see when the unit is installed on a RAID controller.)

Figure 52 Top View and Bottom View of the RCM01 Module

1.

Remote Cable Connector

2.

Board-to-Board Connector

Record your controller serial number in a safe location in case you need to contact Avago.

2.6.3.2

Removing the RAID Controller from the Host Computer

Follow these steps to remove the RAID controller from the computer.

1.

Turn off the power, and unplug the power cords.

2.

Ground yourself, and make sure that the system is grounded.

3.

Remove the cover from the computer, according to the instructions in the system user’s manual, to allow access
to the controller.

4.

Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.

5.

Place the controller on a flat, clean, static-free surface, and continue with the next procedure.

85075-04

Top View

Bottom View

Board to Board

Connector

Cable Connector