Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 110)

Avago Technologies
- 110 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Attaching the CVFM04 Module to the RAID Controller and by Cable to a CVPM02 Module on
a Remote Mount Board
2.11.2.6 Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall your MegaRAID SAS 9361 RAID controller in a PCIe slot on the motherboard.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Install the RAID controller in a PCIe slot on the motherboard, as shown in the following figure.
NOTE This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; if a
controller is installed in one of these slots, the controller will not
function. Refer to the guide for your motherboard for information
about the PCIe slot.
3. Press down gently, but firmly, to seat the card correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 77 Reinstalling the RAID Controller
Press
Here
3_01658-04
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
CacheVault
Power Module 02
(CVPM02)
CacheVault
Flash Module 04
(CVFM04)
Remote Mount
Board