Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 107)

Avago Technologies
- 107 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Attaching the CVFM04 Module to the RAID Controller and by Cable to a CVPM02 Module on
a Remote Mount Board
2.11.2.3 Installing the Clip on the Remote Mount Board
Follow these steps to attach the clip to a BBU-BRACKET-05 remote mount board.
1. With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the system
is grounded.
2. Remove the clip and the remote mount board module from the package.
3. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
4. Hold the clip so the screw holes on the clip line up with the screw holes on the remote mount board, as shown in
the following figure.
Figure 74 Installing the Clip on the Remote Mount Board
5. Secure the clip to the CVPM02 module in three screw holes with the screws and the nuts.
6. The screws thread through the front of the clip and the remote mount board.
NOTE Center the screwdriver carefully to avoid stripping the screw heads.
Do not overtighten the screws.
A
A
A
Clip
3_00895b-00