Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 48
Avago Technologies
- 48 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU07 Unit
2.4.4.3
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on a motherboard.
1.
With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2.
Insert the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.
NOTE
This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; a
controller installed in one of these slots will not function. Refer to the
guide for your motherboard for information about the PCIe slot.
3.
Press down gently, but firmly, to seat the card correctly in the slot.
Figure 28 Installing the RAID Controller
4.
Secure the controller to the computer chassis with the bracket screw.
5.
Replace the computer cover and reattach the power cords.
6.
Turn on the power to the computer.
Edge of Motherboard
Bracket Screw
Edge of
Motherboard
Press Here
85021-16
Press Here