Yaskawa F7 Drive User Manual User Manual

Page 40

Electrical Installation 2 - 13

Heat Sink Mount Resistor Installation

1. Remove the Drive from its mounting for access to the rear of the heat sink.

2. Attach the Heat Sink Mount Resistor on the back of the Drive’s heat sink with screws M4 x 10mm (0.7mm pitch), as shown

in figure below.

3. Remove the rubber plug and run the braking resistor wires into the hole that leads to the terminal block.

4. Reinstall the Drive in its mounting position.

5. Connect the leads from the Heat Sink Mount Resistor to the Drive terminals B1 and B2.

6. Proceed to “Adjustments” section on page 2-18.

Fig 2.5 Attaching Heat Sink Mount Resistor on Heat Sink