Yaskawa F7 Drive User Manual - Manual (Page 15)

Physical Installation 1 - 4
Drive Model Numbers
The model number on the nameplate indicates the design specification, voltage, and rating of the Drive in alphanumeric codes.
Fig 1.2 Drive Model Number Structure
Drive Enclosure and Revision Code
The SPEC number on the nameplate indicates the voltage, Drive rating, enclosure type, and the revision code of the Drive in
alphanumeric codes. The SPEC number for Drives that have custom features, i.e. CASE software, will have a SPEC number
that indicates the custom features installed.
Fig 1.3 SPEC Number Structure
TERMS
Open Chassis Type (IEC IP00)
Protected so that parts of the human body cannot reach electrically charged parts from the front when the
Drive is mounted in a control panel, also called protected chassis.
NEMA Type 1 (IEC IP20)
The Drive is shielded from the exterior, and can thus be mounted to the interior wall of a building
(not necessarily enclosed in a control panel). The protective structure conforms to the standards of NEMA 1
in the USA. All protective covers (Fig 1.4 and Fig 1.6) must be installed to conform with IEC IP20 and NEMA
Type 1 requirements.
No. Spec
UL Specification
CIMR – F7 U 2 0 2 2
AC Drive
U
No. Voltage
2
4
3-phase, 208-240Vac
3-phase, 480Vac
Rating
F7 Family
2 0 2 2 1 E
No.
2
4
Voltage
3-phase, 208 - 240Vac
3-phase, 480Vac
No. Enclosure Type
0 Open chassis (IEC IP00)
1 NEMA Type 1 (IEC IP20)
Hardware Revision
Rating