NavCom StarUtil-3000 Rev.G - Manual (Page 99)

StarUtil 3000 User Guide – Rev G
6-97
statement will be lost as a result of the receiver changing baud rates and the PC remaining at
57600 bps (see Figure 93).
[OUTPUT]PANICA,ONCHANGE,,ETH2
[PORT]1,115200,8,1,NONE
[PORT]2,19200,8,1,NONE
[PORT]3,57600,8,1,NONE
[PORT]4,57600,8,1,NONE
[2DNAVMODE]AUTO,0.0000
[PDOPLIMIT]10.0
[RTKTIMEOUT]15.0
[RTKFLOATTIMEOUT]300
[RTKMODE]rover,NCT,1
[PRDGPSMODE]RTCM1,OFF
[PRDGPSMODE]WAASEGNOS,ON
[PRDGPSTIMEOUT]RTCM1,300
[PRDGPSTIMEOUT]WAASEGNOS,300
[REFSTNPOS]0,0,0.000000,0,0,0.000000,0.000000
[L1FALLBACK]OFF
Figure 92 : Example User Profile
– Control Port
[OUTPUT]PANICA,ONCHANGE,,ETH2
[PORT]1,115200,8,1,NONE
[PORT]2,19200,8,1,NONE
[PORT]3,57600,8,1,NONE
[PORT]4,57600,8,1,NONE
[2DNAVMODE]AUTO,0.0000
[PDOPLIMIT]10.0
[RTKTIMEOUT]15.0
[RTKFLOATTIMEOUT]300
[RTKMODE]rover,NCT,1
[PRDGPSMODE]RTCM1,OFF
[PRDGPSMODE]WAASEGNOS,ON
[PRDGPSTIMEOUT]RTCM1,300
[PRDGPSTIMEOUT]WAASEGNOS,300
[REFSTNPOS]0,0,0.000000,0,0,0.000000,0.000000
[L1FALLBACK]OFF
Figure 93 : Example User Profile – Broken Communication Link Results in Lost Commands

Scrolling command mnemonics in the Communication window indicate a valid
connection.
Scrolling lines designated as “DATA” indicate a broken communication
link (see Figure 94 ).
Figure 94: Indication of Broken Communication Link
 Perform these steps to avoid the user profile loading error explained above:

Move the [PORT] commands to the end of the user profile. In addition, move the control port
command to the bottom-most position (see Figure 95).
Lost Commands