Point radius, Starfire satellites, Before uploading a starfire license – NavCom StarUtil-3000 Rev.G User Manual
Page 113: Figure 105: starfire rtg on, Table 14: starfire satellites v3.0.12 and later, Ated table 14, Figure 105), Figure
StarUtil 3000 User Guide
– Rev G
7-111
Point Radius
This feature applies only to receivers with a Land Only StarFire license. The Point Radius
definition is separate from the StarFire license. It allows the use of StarFire if the user is outside
the boundary lines of a Land Only StarFire license, but on a land mass (i.e., an island).
The user must provide the coordinates to NavCom Customer Service for the Point Radius
definition. NavCom provides StarFire use at the coordinates and within a determined radius.
The Point Radius definition is only for one point and radius circle.
StarFire Satellites
Table
14
: StarFire Satellites v3.0.12 and Later
Network
Satellite ID
Longitude
Satellite
Name
Uplink Site
Net 1
402
97.65W
PAC-E
Laurentides
643
143.5E
PAC-W
Auckland
525
25E
IND-W
Burum
Net 2
678
178E
POR
Santa Paula
564
64E
IND-E
Perth
446
54W
AOR-W
Southbury
484
15.5W
AOR-E
Southbury
Before Uploading a StarFire License
Before uploading a StarFire License, either by data cable or Over the Air (OTA) StarFire
Licensing, ensure that the receiver is configured for StarFire. The navigation mode, StarFire
RTG, must be set to ON in the Set Navigation Modes window (see Figure
) to enable
StarFire navigation.
Figure
105
: StarFire ON