NavCom StarUtil-3000 Rev.G - Manual (Page 105)

StarUtil 3000 User Guide – Rev G
6-103

Click on the Profile File Name box and select a local user profile file (*.npt). (The
path to the selected file is displayed in the Profile File Name box.)
3. Click to preview the user profile in Microsoft Notepad.
4. Select the Un-check to load defaults before loading profile check box.

If this box is not selected, the receiver baud rate reverts to 57600 baud (the profile
does not load if the port is currently operating at a different baud rate).
5. Click .

If the profile loads successfully, the following confirmation message is displayed:

Click the OK button. The profile name is displayed in the
PROFILE in use text box at the bottom of the Save/Load/Delete User
Profile dialog box (see Figure 97).

If the file does not load, there is no response. Confirm
that the baud rate is correct. Also, expand and scroll through
the Input Terminal window to verify that none of the parameters in the profile were
rejected.
Use a Profile Selected from the Profile List
Figure 101: Use Profile in List of Profiles
Refer to Figure 101 for the steps below:
1. Select the option Use the profile selected in the list of Profile(s).
2. Click to refresh the List of Profile(s).
3. Click the downward pointing arrow on the List of Profile(s) field and select a profile from the
list.
4. Click the Use button: