NavCom StarUtil-3000 Rev.G - Manual (Page 21)

StarUtil 3000 User Guide – Rev G
xix
Rev B (September 2010) (continued)
Chapter/Item Revision Description
Chapter 6, User
Profiles
Extensively updated this chapter to reflect changes in how the GUIs
function and updated the GUI graphics;
More specifically: updated the [TRACKINGMODE] and [ALM1B]
command information; updated the example in Creating a User Profile
section; updated Figure 88 (formerly Figure 69) to show
WAASEGNOS “off”; added a note under NAVMEASUSE that WAAS
satellites contain similar signaling characteristics to GPS and that
current software does not support WAAS measurement data in nav
solution; added Bundle A to Table 11; in the beginning of the Avoiding
User Profile Loading Errors section, added that StarUtil 3000 v1.0.0
and later scans user profiles before loading them, but that
communication errors still occur
Chapter 7, Starfire
Satellites
Updated Table 14 to reflect reassignment of satellites. Satellite ID
#609, which was in Net1, is now Net2. Satellite 643, which was in
Net2, is now Net1; added note re this reassignment
Chapter 7, Before
Uploading a StarFire
License Updated instructions for setting navigation modes and updated GUI
Chapter 7, Upload a
StarFire License via
the Input Terminal Added instructions on uploading a StarFire license using the
[INPUTSFLICENSE] command
Chapter 7, How to
Cancel StarFire
License Added a warning that this action cancels the subscription to StarFire
and that users need to contact their dealer or NavCom to replace their
license
Chapter 7, Setting Up
a StarFire Priority
Network Added section; added tables re reassignment of StarFire Network List
Chapter 8, RTK Setup
Added the command [ENABLEGEOFENCE]; updated the User Profile
examples (Figure 126 and Figure 127); corrected typo
[ANTENNAHIGHT] and updated [RTKMODE], [REFNAME], and
[SELFSURVEY] command descriptions; added
[GLONASSCORRECTION] to Solution Control; added Set Up the
Moving Base section; updated Set Navigation Modes section and
updated the corresponding GUI
“Set Navigation Modes”
Chapter 9, Display of
Positioning
Performance Added reference to new [ANTENNAINFO] command; added section
on manually selecting SBAS PRN numbers;
Chapter 10, Data
Logging Added new file system management commands; added new steps for
logging data to a mass storage device
Rev A (Oct 2009) Initial release