NavCom StarUtil-3000 Rev.G - Manual (Page 166)

StarUtil 3000 User Guide – Rev G
11-164
Figure 155 : Data Parsing Options
Refer to Figure 155 for the options below:
 Time Start/Time End: Enter a specific time to use as the start and/or end time. Only data
appropriate to the timestamps in these fields is extracted.

Entering only a start time leaves out the data that has an earlier timestamp.

Entering only an end time extracts all data that has a timestamp less than the entered
value.

Entering Start/End times is useful to focus on an issue that occurred during a
specific time period.
 Write to Disk after [sec]: Enter the interval in seconds for the log file to be processed. For
example, a log file has PVT1B data at 10Hz. To extract the PVT1B data to the *.txt file at a
1Hz interval, enter 1 in the field.
 Format PVT and MEAS for Matlab: Check to extract the data in Matlab format.
Simulation
The simulation dialog box provides a simulation of receiver operation via the playing of a saved
log file (*.dat).
Figure 156: Simulation Dialog Box