NavCom StarUtil-3000 Rev.G - Manual (Page 72)

StarUtil 3000 User Guide – Rev G
3-70
Figure 72: Settings for GNSS Firmware
Set these options:

Baud Rate:

Serial Connection: Refer to the section above, PC Baud Rate Requirements for
Firmware Upload Via Serial Connection .

USB 2.0 Device or Ethernet Connection: No selection is necessary. The speed of the
connection is automatically set.

Target:

Select SOLARIS to upload GNSS [firmware (see Figure 72) .
Or

Select SOLARIS PIO to upload PWRIO firmware (see Figure 73).
Buffer Size: Do not set this option. The program automatically sets it.
Bootloader: Do not set this option. The program automatically sets it.
Force Load Firmware Without PING: Keep the default (unchecked).
Figure 73: Settings for PWRIO Firmware
7. Click . A Progress dialog box opens. At the end of the upload, a “Finished
loading ” message indicating the number of bytes downloaded is displayed on the Progress
dialog box (see Figure 74). Click to continue.