NavCom StarUtil-3000 Rev.G - Manual (Page 124)

StarUtil 3000 User Guide – Rev G
7-122
Figure 123 : Satellite Locations – User-Defined Satellite
Define Satellite Window
With direction from NavCom, use this window on the StarFire tab to add or delete one licensed
user-defined StarFire satellite to be available for automatic or manual selection. The
user-defined satellite is a new satellite in the StarFire network or a backup StarFire satellite.

Only one satellite can be user-defined. A new user-defined satellite overwrites the
previous user-defined satellite.
Figure 124 : Define Satellite
Refer to Figure 124 for the steps below:
 Enter User-Defined Satellite
1. With direction from NavCom, enter the Frequency (KHz) and the Satellite ID for the
user-defined satellite.
2. Click the Save button.
3. Confirm that the entry of the user-defined satellite is successful:
4. Click (refresh) on the Satellite Locations window to view the current output data. The
satellite ID of the user-defined satellite is on line 7 (see Figure 123).
 Delete User-Defined Satellite
1. Click the Retrieve button. The user-defined satellite is retrieved from the receiver.
2. Click the Delete button.
3. Confirm that the user-defined satellite is deleted:

Click (refresh) on the Satellite Locations window to view the current output data. The
satellite ID, User, on line 7 indicates that there is no current user-defined satellite (see
Figure 122).