NavCom StarUtil-3000 Rev.G - Manual (Page 56)

StarUtil 3000 User Guide – Rev G
2-54
4. On the Input Terminal window, re-enter the [ETHVCOM] command with no parameters to
verify the EVCOM settings:
[ETHVCOM] ON, 0.0.0.0, 0, UDP2, 4361, ETH1
[ETHVCOM] OFF, 0.0.0.0, 0, UDP1, 4362, ETH2
[ETHVCOM] OFF, 0.0.0.0, 0, TCP1, 4363, ETH3
[ETHVCOM] OFF, 0.0.0.0, 0, TCP1, 4364, ETH4

To verify a simple direct connection on port ETH1, enter the [PING] command on
the Input Terminal. The response should be [PING]ETH1.
5. On the Input Terminal window, enter [ETHCONFIG] to view the current Ethernet Port IP
settings to use for the connections dialog:
[ETHCONFIG]AUTO,204.54.86.4,255.255.254.0,204.54.87.1,204.54.87.20,204.54.87.39,
where:
“204.54.86.4” is the SF-3050 IP address; make a note of this
“255.255.254.0” is the network address mask
“204.54.87.1” is the gateway address
“204.54.87.20”is the primary DNS server
“204.54.87.39” is the secondary DNS server
The [ETHCONFIG] command can also be entered with MANUAL. (MANUAL
means assign a fixed IP and AUTO means use DHCP.) You can use AUTO,
but keep in mind that if the receiver drops offline, it may be difficult to retrieve
the IP address. If you specify MANUAL, the IP address does not change if
the receiver drops offline for power cycle, for downline load of new firmware,
etc.
If the MANUAL IP address is used other than on a direct connection between
a PC and the SF-3050, the user should have enough knowledge of
networking to ensure that the selected IP address does not conflict with other
units connected to the same LAN and is a valid address for that network.

The logical ports ETH1-ETH4 are used when configuring output messages on the
Ethernet ports (e.g., [OUTPUT]PVT1B,ONTIME,1,ETH1).

To make a change to [ETHCONFIG] permanent, enter [PROFILE]SAVEAS
“PROFILENAME” and power cycle the receiver. This change will not take effect
until after the power cycle.
Example:
[ETHCONFIG]MANUAL,204.54.86.4,255.255.254.0,204.54.87.1,204.54.87.20,
204.54.87.39
Basic Ethernet Configuration: Direct Connection via Static IP Address
Setup
This setup uses the factory default IP address of the SF-3050: