Measurement Computing WaveBook rev.3.0 - Manual (Page 198)

D-2 daqX API - Command Reference, 6-24-99 WaveBook User’s Manual
Custom ADC Acquisition Prototypes - Scan Count, Rate and Source
daqAdcSetAcq
Set acquisition configuration information D-9
Custom ADC Acquisition Prototypes - Direct-to-Disk
daqAdcSetDiskFile
Specify the disk file for direct-to-disk transfers D-10
Custom ADC Acquisition Prototypes - Acquisition Control
daqAdcArm
Arm an acquisition D-3
daqAdcDisarm Disarm an acquisition D-4
Custom ADC Acquisition Prototypes - Data Transfer without Buffer Allocation
daqAdcTransferBufData
Transfer scans from driver-allocated buffer to user-specified buffer D-15
daqAdcTransferSetBuffer Setup a destination buffer for an ADC transfer D-17
daqAdcTransferStart Start an ADC transfer D-17
daqAdcTransferGetStat Retrieve status of an ADC transfer D-16
daqAdcTransferStop Stop an ADC transfer D-18
Custom ADC Acquisition Prototypes - Buffer Manipulation
daqAdcBufferRotate
Reorganize a circular buffer so oldest data is oriented towards the
front
D-3
One-Step ADC Acquisition Prototypes
daqAdcRd
Configure an A/D acquisition and read one sample from a channel D-6
daqAdcRdScan Configure an A/D acquisition and read one scan D-7
daqAdcRdN Configure an A/D acquisition and read multiple scans from a channel D-6
daqAdcRdScanN Configure an A/D acquisition and read multiple scans D-8
Data Format and Conversion Prototypes
daqAdcSetDataFormat
Set the raw and the post-acquisition data formats D-10
daqCvtRawDataFormat Convert raw data to a specified format D-21
daqCvtSetAdcRange Set the ADC Voltage Range for the conversion routines D-21
Software Calibration Prototypes
daqCalSelectCalTable
Select calibration-table source for the device D-19
daqCalSelectInputSignal Select input signal source for user calibration D-19
daqCalGetConstants Get calibration constants from selected calibration table D-18
daqCalSetConstants Set user-accessible calibration constants D-20
daqCalSaveConstants Save current calibration table D-19
General I/O Prototypes - Read/Write
daqIOReadBit
Read a DIO bit (channel) D-25
daqIORead Read a DIO byte (8 channels) D-24
daqIOWriteBit Write a DIO bit (channel) D-26
daqIOWrite Write a DIO byte (8 channels) D-25
Test Prototypes
daqTest
Perform a specified test on a Daq* device D-29