Measurement Computing WaveBook rev.3.0 - Manual (Page 11)

WaveBook User’s Manual, 6-24-99 Quick Start QS-3
3. Connect Power
WaveBook can be powered from the included wall-mount AC adapter (TR-40U) or from a 10 to 30 VDC source, such
as a car battery. The AC adapter plugs into a standard wall outlet, and its DIN5 end plugs into the DIN5 “Power In”
receptacle on WaveBook’s rear panel.
AC Adapter Connection
Power options include the DBK30A (a rechargeable battery module) and the DBK34 (uninterruptible power supply
module).
Reference Note: If using DBK30A or DBK34, refer to the following sections of your user’s manual for
additional information.
• Chapter 3, WaveBook Expansion Options
• Chapter 4, System Power & Assembly
4. Install Software
WaveBook software includes WaveView, a Windows-based data acquisition program. For successful operation, your
computer should have the following, as a minimum:
• Microsoft Windows 95/98/NT
• 5x86 or Pentium ® processor
• 16 Mbytes of RAM (32 Mbytes recommended)
Remove any previous-installed version of the WaveBook drivers before installing a new version.
Install software according to the following procedure.
1. Close all other programs. Use the Microsoft Windows Run dialog box and direct Windows to the
SETUP.EXE
file
found on Disk 1 (or CD-ROM, if applicable). Follow the on-screen dialog boxes to complete the installation.
2. When the installation is complete, check the WaveBook program group and verify all programs are present.