Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 73)

InstallatIon
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 2-25
Beam delivery optical cable connection
The optical power from the fiber laser supply is delivered through the beam delivery optical cable/optics. Because of the
small surface area and the high power levels, cleanliness of the input and output optical surfaces is critical to component
lifetime and proper operation. The optical surface at the bayonet end of the Beam delivery optical cable should be
inspected, with the magnifier that was supplied with the system, before installation and whenever it is removed from the
collimator. To prevent contamination and chipping, the optical surface should not be touched. See page 4-4 for details
of the inspection and cleaning procedure.
Caution: the minimum bend radius of the Beam delivery optical cable is 100 mm
(4 in). the fiber can be damaged if the radius is any smaller.
1
100 mm
(4 in)
100 mm
(4 in)
200 mm
(8 in)
Diameter = 2 x radius = 200 mm (8 in)
Beam delivery optical cable part numbers
Part number Length
051029 10 m (33 ft) 100 micron
051030 20 m (65.5 ft) 100 micron
051045 20 m (65.5 ft) 200 micron