Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 61)

InstallatIon
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 2-13
• Store straps in a proper manner such that they are not subjected to mechanical, chemical, or ultraviolet damage,
or to extreme temperatures.
The body responsible for the workplace where the equipment is to be installed needs to make sure all applicable local
regulations are followed, and Hypertherm assumes no responsibility or liability therefor. The customer assumes exclusive
responsibility for ensuring that all local laws and regulations are followed, including those applicable to the use of
equipment and work place conditions.
Fiber laser supply preparation
General information
The installations on the following pages should be performed before making any other connections to the fiber laser
supply.
WARNING
• Operation and maintenance of automated equipment involves potential hazards.
• Only authorized service personnel should perform this service.
• REMOvE ALL POWER tO tHE FIBER LASER SUPPLy ENCLOSURE BEFORE BEGINNING
PROCEDURE.
• Warning undesired results may occur if these instructions are not followed exactly in order
without skipping any steps