Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 209)

Maintenance
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 4-17
Status Message Description
Safety Relay Interlock Fault Safety relay is off (the safety circuit is in the open state)
Contactor 1 Fault Safety contactor 1 malfunction
Contactor 2 Fault Safety contactor 2 malfunction
Interlock Circuit 1 is Open Front door of laser power control unit is open
Interlock Circuit 2 is Open Rear door of laser power control unit is open
Delivery Fiber BDO-1 Fault Fiber BDO interlock circuit malfunction
Delivery Fiber BDO-2 Fault Fiber BDO interlock circuit malfunction
Fiber Combiner Fault Combiner optical power sensor limit exceeded
Laser Supply Temperature Fault Power supply temperature limit exceeded
Laser Supply Current Fault Power supply current limit exceeded
24VDC Field Supply Fault Laser controller field supply voltage out of range
Lens Door Open Fault Laser head lens door is open
Head Collision Fault Laser head collision
Laser Head Faulted Laser Head is being calibrated or has an active fault
CNC Protocol Mismatch Incompatible Pheonix version detected. Must upgrade pheonix to
9.72.2 or higher.
Ethernet Cable Disconnected The ethernet cable is disconnected from Laser Power Controller
inside the laser power supply, or the ethernet switch is not
working.
CNC Communications Timeout CNC communications error
LHC Communications Timeout Laser head controller communications error
LPC Communications Timeout Laser power controller communications error
Module 1 Low Power Error Laser module 1 not producing expected output power. Latches
after 3rd occurance. System should not be operated at full power
until factory consultation. Permanent Laser damage could result
Module 2 Low Power Error Laser module 2 not producing expected output power. Latches
after 3rd occurance. System should not be operated at full power
until factory consultation. Permanent Laser damage could result
Module 3 Low Power Error Laser module 3 not producing expected output power. Latches
after 3rd occurance. System should not be operated at full power
until factory consultation. Permanent Laser damage could result
Module 4 Low Power Error Laser module 4 not producing expected output power. Latches
after 3rd occurance. System should not be operated at full power
until factory consultation. Permanent Laser damage could result
Module 5 Low Power Error Laser module 5 not producing expected output power. Latches
after 3rd occurance. System should not be operated at full power
until factory consultation. Permanent Laser damage could result
Module 6 Low Power Error Laser module 6 not producing expected output power. Latches
after 3rd occurance. System should not be operated at full power
until factory consultation. Permanent Laser damage could result