Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 123)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-15
Push to Select
+ =
Configuration
screen
Push to Select
+ =
Diagnostics
screen
Diagnostics screen navigation
Note: The process shown below can also be followed to verify the parameters in the LHC SERVICE MODE by
choosing “more” after verifying the LPC parameters.
Verify the LPC parameters on the screen shown above by comparing them with the data in the LPC service mode
parameters tables at the end of section 4, Maintenance, of this manual. Verify the LHC parameters by comparing the
values shown on the LHC diagnostics parameters screen with the data in the LHC diagnostic parameters tables at the
end of section 4, Maintenance, of this manual.
Push to Select
+ =
LPC SERVICE
MODE screen
Push to Select
+ =
LPC
parameters
screen
LHC Ver: 1.13 LPC Ver: 1.17 P2
LPC SERVICE MODE
DIN Status DOUT Status
AIN Status AOUT Status
LPC SERVICE MODE
DIN 0-7
AIN 8-15 DOUT 16-23
AOUT 24-31
PS Flt Off PF Flw Off
DR Int1 Off Safe Rly Off
DR Int2 Off Cont1 Off
FCU Leak Off Cont2 Off
Laser power 1500W O2 12 PSI
Beam ON System OK