Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 157)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-49
Cut direction
Cut direction
Example 13: Bad nozzle centering
In this example, the correct cut chart was used, but the nozzle is not centered. The photos below are opposite sides of
the same part. The cut edge is different depending on the cut direction.
thickness
Nozzle Cut parameters
type and
size (mm)
Nozzle
extension
Creep
time
Cut
pressure
Cut
height
Kerf
width
Cut
power
Cut
speed
6 mm
(0.25 in.)
D1.5 23 mm 0.2 sec 0.55 bar
(8 psi)
1 mm
(0.04 in.)
0.35 mm
(0.014 in.)
2000 W 1800 mm/min
(72 in./min)