Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 141)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-33
50% duty cycle at 100% power
10 VDC = maximum rated power in watts
5 VDC = 50% duty cycle
24 VDC
24 VDC
1600 watts
Pulse rate always 500 Hz
Process Power
Corner Power
Corner Power
Enable
Digital Beam
Enable
Laser Output
10% duty cycle at 100% power
10 VDC = maximum rated power in watts
1 VDC = 10% duty cycle
24 VDC
24 VDC
1600 watts
Pulse rate always 500 Hz
Process Power
Corner Power
Corner Power
Enable
Digital Beam
Enable
Laser Output
Pulsing the fiber laser using a generic CNC
Pulsing the laser using the integrated Pulse Width Modulation (PWM)
1. Set the Process Power between 0 and 10 volts (0-100% of rated power in watts)
2. Set the Corner Power/PWM duty cycle. 0-10 volts = 0-100% PWM duty cycle
3. Set corner Pulsing Enable Input
4. Turn ON Digital Beam Enable
The laser will always pulse at 500 Hz using this mode
Note: You can change level of Process Power or Corner Power at any time during beam on. Pulsing Process
Power or Corner Power in this mode is not recommended.