Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 223)

Maintenance
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 4-31
Pin Signal
A-1 Process power (analog input) 1
A-2 Analog common
A-3 Corner power (analog input) 1
A-4 Analog common
A-5 Assist gas pressure setpoint (analog input) 1
A-6 Analog common
A-7 Capacitive height sense (analog output - 1 volt/mm)
A-8 Analog common
A-9 Laser fault output_A 2
B-2 Gas fault output_A 2
B-3 Gas fault output_B 2
B-4 Digital beam enable input 3
B-5 Pointing laser enable input 3
B-6 Corner power pulsing enable input 3
B-7 Side jet enable input 3
B-8 Laser fault reset input 3
C-1 Over range output_B 2
C-2 Pointing laser status output_A 2
C-3 Pointing laser status output_B 2
C-4 Laser head fault output_A 2
C-5 Laser head fault output_B 2
C-6 Nozzle contact output_A 2
C-7 Nozzle contact output_B 2
C-8 Over range output_A 2
C-9 Laser fault output_B 2
Part Part number
Mating connector 108945
22-24 AWG sockets 108946
Connector housing 108941
Cable strain relief 108942
Crimp tool made by
Phoenix Contact
1687419
Notes: 1 These analog inputs are 0 – 10 VDC single ended inputs
2 These discrete outputs are dry relay contacts (5 – 24 VDC @ 0.2 amps)
3 These discrete inputs require a positive voltage (12 – 34 VDC) to activate the input
HyIntensity Fiber Laser Machine Interface
Note: Go to page 4-32 to see examples of typical interface circuits.
LPC 1