Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 239)

HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 C-3
HFL Instruction Manual revision 2 changes (807090)
Changed
Page
Description of changes for revision 2 (date of revision - 1/2012)
Cover
Added information about the HFL010 and HFL020 so this manual now covers all 3 of the Hypertherm
HyIntensity lasers.
Universal
change
HFL015 replaced by HyIntensity fiber laser where ever it appears.
S5 and S7 Added 2 new wavelength output stickers to the safety section.
1-2 Added part numbers for the HFL010 and the HFL020 laser supplies.
1-3 Added the rated power output for the HFL010 and the HFL020 laser supplies.
1-4 Added weights for the HFL010 and HFL020 laser supplies.
1-8
Added flow rate and cooling capacity information for the HFL010 and the HFL020 chiller
requirements.
2-4 and 2-5 Rearranged the order of the system components to fit the reorganized order of component installation.
2-24
Added instruction about installing the laser head mounting bracket to the laser head, and using the
protective cap.
2-25
Spread out the dimensional drawings of the laser head and the grounding of the laser head over 2
pages. It was previously crowded onto 1 page.
2-27 to 2-31 Added more detail and pictures to the collimator installation instructions.
2-34 Added the part number for the 20 m (65.5 ft), 200 micron beam delivery optical cable.
2-38 through
2-40 and 2-46 Removed part numbers for the beam delivery optical cable and collimator coolant hoses.
2-45 Changed the graphic of the cable to show the correct part.
2-52 Added the text “but they must meet the pressure requirements (see section 1, specifications).
2-59
Changed lens installation (installing a lens in a lens holder) to lens assembly installation (installing a
lens assembly into the lens bay in the laser head).
3-4 and 3-5 Updated the flow charts.
3-6 Updated the diagram.
3-25 Removed the in-line graphic of the selection knob for clarity.
3-35 Added laser output in watts for the HFL010 and the HFL020.
3-41 Updated the consumables table.
3-42 through
3-44
Added cut charts for the HFL010.
3-48 through
3-50
Added cut charts for the HFL020.
3-51 Added the heading “Setting the IP address.”
3-53 Changed the heading from programming to Upgrading the firmware.
4-8 Removed the examples of cleaners that should NOT be used.
4-9 Updated the graphic of the exploded view to include the lens window and lens holder washer.
4-12 Added step 6 “installing the lens window”.
4-30 Corrected the mating connector part numbers.
5-2 Added the part numbers for the HFL010 and HFL020 fiber laser supplies.