Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 220)

Maintenance
4-28 HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3
DOUt Status 0 – 15
DOUt 0
GRN STK1 On = Cabinet green stack light ON
Off = Cabinet green stack light OFF
DOUt 1 YEL STK1 On = Cabinet yellow stack light ON
Off = Cabinet yellow stack light OFF
DOUt 2 RED STK1 On= Cabinet red stack light ON
Off = Cabinet red stack light OFF
DOUt 3 GRN STK2 On = External green stack light output contact closed
Off = External green stack light output contact open
DOUt 4 YEL STK2 On = External yellow stack light output contact closed
Off = External yellow stack light output contact open
DOUt 5 RED STK2 On = External red stack light output contact closed
Off = External red stack light output contact open
DOUt 6 PTL CMD On = Internal pointing laser contact closed
Off= Internal pointing laser contact open
DOUt 7 CNTRL OK On = Laser power controller OK
Off = Laser power contoller Flt
DOUt 8 LASER FLT On = Laser fault active output contact closed
Off = Laser fault inactive output contact open
DOUt 9 PLT STATUS On = Pointing laser on output contact closed
Off = Pointing laser off output contact open
DOUt 10 LH FLT On = Laser head fault active output contact closed
Off = Laser head fault inactive output contact open
DOUt 11 TIPTOUCH On = Nozzle contact active output contact closed
Off = Nozzle contact inactive output contact open
DOUt 12 LH OR On = Overrange output active output contact closed
Off = Overrange output inactive output contact open
DOUt 13 GAS FLT On = Gas fault output active output contact closed
Off = Gas fault output inactive output contact open
DOUt 14 PS ENB On = Power supply interlock enabled
Off = Power supply interlock disabled
DOUt 15 H20 VALVE On = Input water valve open
Off = Input water valve closed
AOUt Status
PS CMD
Power supply command (0 – 10 Volts = 0 to 100%)
CHS Scaled capacitive height sensor voltage (0 – 10 Volts = 0 – 10 mm)