Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 238)

C-2 HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3
HFL Instruction Manual revision 3 changes (807090)
3-82 Added a note about Laser firmware being included in Phoenix version 9.72.1 and higher.
4-13 Replace the two photographs at the bottom of the page with line art for clarity.
4-16 and 4-17 Added a note saying “module 5 and 6 errors are only for HFL030.”
Added the information for the HFL030 and updated all status and descriptions for clarity.
4-25 Added a note about I/O points that automatically change to “virtual” when using HyperNet.
4-26 Added a new page with DIN status 20 - 31. This was left out by error in the last revision.
4-27
Added a note saying that signals are identified as “spare” when not used. Update the table with
HFL030 information.
4-33 Removed “Use internal field + 24 VDC” from the right side of the graphic at the bottom of the page.
5-2
Updated the fiber laser supply part numbers and descriptions for HFL010, 015, and 020, and a
added part numbers and descriptions for HFL030. Moved other part information to the next page.
5-3 Added a new page for the components that were moved from page 5-2.
5-6 Added a heading “ LF150 cutting head - lower parts” to the page.