Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 59)

InstallatIon
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 2-11
DANGER
ELECtRICAL SHOCK CAN KILL
Remove all electrical connections to the laser power supply before moving or positioning.
transporting the fiber laser supply can cause personal injury and equipment damage.
The fiber laser supply can be moved by forklift but the forks must be long enough to extend the entire length of the base.
Take care when lifting so that the underside of the fiber laser supply, and the drain that comes through the underside of
the fiber laser supply (HFL010, HFL015, and HFL020 only), are not damaged.
• Place the fiber laser supply in an area that is free of excessive moisture, has proper ventilation, and is relatively
clean. Allow 1 m (3 ft) on all sides of the fiber laser supply for servicing.
• Do not place the power supply on an incline greater than 10° to prevent it from toppling.
Note: The graphic below shows the enclosure for the HFL010, HFL015, and HFL020
The drain is located on the
underside of the enclosure
at this corner.
A Placement of the fiber laser supply