Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 95)

Power switch
G&D DVICenter · 87
Power switch
By integrating a remote power switch (G&D Hardboot CCX) into the matrix system,
you can (de)activate the power supply of the devices through the system.
For this, one or several power outlets are assigned to a target module. Afterwards,
the outlets can be switched in the Operation menu.
Switching the power outlets assigned to the target
The Target power function enables you to switch the power outlets of a connected and
configured power switch.
How to switch on/off the power outlets assigned to the currently accessed target
module:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F9 to call the Operation menu.
3. Press I (repeatedly) or select the I - Target power entry and press F8 (repeatedly) to
select one of the following options:
Requirements to use this function:
 Installed G&D Hardboot CCX power switch
 A power switch power outlet that is assigned to the target module (see page 90)
 Assigned target rights (see page 88) or target group rights (see page 89) for power switching
IMPORTANT: At first, access the target whose assigned power outlet you want to
switch (see page 4).
off: switches off power outlets
on: switches on power outlets
IMPORTANT: The »n.c.« entry (not connected) indicates that no power outlets of
a power switch that is connected to the matrix system are assigned to the
accessed target module.
ADVICE: After the on-screen display has been called, you are enabled to activate
the Target power function in the Select menu by pressing Ctrl+I .