Changing the sort criteria of the list entries, Limiting the entries using the view filter – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 18
The On-Screen Display (OSD)
10 · G&D DVICenter
Changing the sort criteria of the list entries
In the default settings, the list entries are sorted alphabetically in ascending order
(default:
Alph+
).
Targets are listed according to their operating status. Active devices are displayed at
first, followed by all inactive devices. Both groups are sorted in ascending order
(default:
Alph+on
).
You can also activate another sort criterion or reverse the sort order.
How to change the sort criteria and/or sort order:
1. Press the
Ctrl+Num
(default) hotkey to open the on-screen display.
2. Press the
Tab
key to select the
Sort
field in the header.
3. Press
F8
to select the desired sort criterion:
Limiting the entries using the view filter
The
Show
field enables you to limit the list of entries in the list field of some menus:
The Select menu lists all target modules by default. The view filter can limit the target
module list of a particular view group (marked as folder in the web application).
Alph+:
The names of the list entries are sorted alphabetically in ascending
order.
Alph+on:
Active devices are displayed at first, followed by all inactive
devices. Both groups are sorted in ascending order.
This option is only available in the device list.
Alph-:
The names of the list entries are sorted alphabetically in descending
order.
Alph-on:
Active devices are displayed at first, followed by all inactive
devices. Both groups are sorted in descending order .
This option is only available in the device list.
ID:
The names of the list entries are sorted in ascending order accord-
ing to the physical device ID.
This option is only available in lists that include target modules.
ADVICE:
Further information regarding the administration of the target modules
of a view filter are provided in the chapter Administrating view filters on page 55 ff.
NOTE:
If the Config Panel web application is used to create and administrate groups
(folders) for the view filter, any number of folders can be added to the superior
folder.
The on-screen display only shows the superior view filter. The included target
modules of inferior locations are automatically listed.