Activating or resetting a ps/2 mouse – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 90
User modules
82 · G&D DVICenter
How to auto-disconnect the access to a target module:
1. Press the
Ctrl+Num
(default) hotkey to open the on-screen display.
2. Press
F11
to call the Configuration menu.
3. Select the
Console
entry and press
Enter
.
4. Select the user module whose settings you want to change and press
F5
.
5. Select the
Auto disconnect (min)
entry and press
Enter
.
6. Enter a number between
1
and
99
minutes to start the screensaver and press
Enter
.
7. Press
F2
to save your settings.
Activating or resetting a PS/2 mouse
Compared to USB mouses, PS/2 mouses do not support hot plug technology. You
can therefore insert the PS/2 plug during operation, but it may be possible that the
computer does not detect the input device.
In order to activate or reset the PS/2 mouse, the matrix system can be used to send
a special command to the computer connected to the target module.
Further information regarding this topic are provided in the chapter Target modules
Viewing technical information about the user modules
The Console status menu provides detailed information about the user modules and
displays e.g. the physical ID, the accessing user, and the firmware version.
How to call detailed information about the user modules:
1. Press the
Ctrl+Num
(default) hotkey to open the on-screen display.
2. Press
F12
to call the Information menu.
3. Select the
Console status
entry and press
Enter
.
ADVICE:
Use the menu’s search function or the sort criteria (see page 9 ff.) to limit
the selection of list entries.
NOTE:
The value »0« deactivates the auto disconnection when a target module
is accessed.