Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 69)

Target modules
G&D DVICenter · 61
5. Select the user account or the user group whose multi access rights you want to
change and press F5 .
6. Select the Target (group) USB access rights entry and press Enter .
7. Select the desired target or target group whose access rights you want to change.
8. Press F8 to select one of the listed options:
9. Repeat steps 7 and 8 to change the access rights to further target modules.
10.Press F2 to save your settings.
Rights for configuring the target modules
How to change the target config rights:
1. Press the
Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F11 to call the Configuration menu.
3. If you want to change this right of a user account, select the User entry.
For changing the right of a user group, select the Usergroup entry.
4. Press Enter .
5. Select the user account or the user group whose rights to edit and configure the
target modules you want to change and press F5 .
6. Select the Config rights entry and press Enter .
7. Select the Target Config entry and press F8 to select one of the following options:
8. Press F2 to save your settings.
Rights to reset or reactivate a PS/2 mouse
Compared to USB mouses, PS/2 mouses do not support hot plug technology. You
can therefore insert the PS/2 plug during operation, but it may be possible that the
computer does not detect the input device.
In order to activate or reset the PS/2 mouse, the matrix system can be used to send
a special command to the computer connected to the target module.
ADVICE: Use the menu’s search function or the sort criteria (see page 9 ff.) to limit
the selection of list entries.
yes: Allow access to USB devices of the channel group.
no: Deny access to USB devices of the channel group.
yes: allows the right to view and edit the target module config
no: denies the right to view and edit the target module config