Displaying cable information – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 115
System settings and functions
G&D DVICenter · 107
How to call the Firmware information:
1. Press
Ctrl+Num
(default) to open the on-screen display.
2. Press
F12
to open the Information menu.
3. Select
Firmware information
and press
Enter
.
The desired information is displayed.
4. Press
Esc
to leave the menu.
ADVICE:
Displaying dynamic port information of the matrix system
Use the Dynamic port menu to query the modes and amount of ports.
How to call the dynamic port information:
1. Press
Ctrl+Num
(default) to open the on-screen display.
2. Press
F12
to open the Information menu.
3. Select
Dynamic port information
and press
Enter
.
The desired information is displayed.
4. Press
Esc
to leave the menu.
Displaying hardware information of the matrix switch
The hardware information of the matrix switch are displayed in the Hardware infor-
mation menu.
This menu lists e.g., the firmware version, the device’s serial number and the MAC
addresses of the network ports.
How to display the hardware information:
1. Press
Ctrl+Num
(default) to open the on-screen display.
2. Press
F12
to open the Information menu.
3. Select
Hardware information
and press
Enter
.
The desired information is displayed.
4. Press
Esc
to leave the menu.
Displaying cable information
The Cable information menu lets you display information about the length and status
of the connected twisted pair cables. This way, transmission errors due to wrong or
damaged cables can be discovered faster.