Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 13)

Getting started
G&D DVICenter · 5
3. Press E or select the E - User logout entry and press Enter .
Starting the functions of the »Operation« menu via
hotkeys
The Select menu is usually displayed after the on-screen display has been called up.
To operate the system, press F9 to call up the Operation menu.
Through the use of hotkeys the functions of the Operation menu can also be carried
out within the Select menu.
How to access a function in the Operation menu by using a hotkey:
1. Press the
Ctrl+Num (default) hotkey to open the on-screen display.
2. Press one of the hotkeys listed in the table below to call up the function:
ADVICE: After the on-screen display has been called up, you can activate the User
logout function by pressing Ctrl+E .
Ctrl+A: Automatic switching of all target modules (Autoscan)
Ctrl+B: Automatic switching of all activated target modules (Autoskip)
Ctrl+C: Manual switching of the target modules (Stepscan)
Ctrl+D: Disconnects the target module (Disconnect)
Ctrl+E: User logout
Ctrl+F: Calls up the Mouse utility function to activate or reset the PS/2
mouse interface of the computer connected to the target module
Ctrl+G: Accesses the previously accessed target module (Return to last target)
Ctrl+H: Shows an additional column in the list field of the Select menu
(Target info)
Pressing the key combination enables you to switch between the
following options:

off: hides additional column
 id: displays the physical ID of the target modules
 select keys: displays the select keys of the target modules
Ctrl+I: Switches the power outlets of a connected and configured power
switch (Target power)
Pressing the key combination enables you to switch between the
following options:

off: switches off power outlets
 on: switches on power outlets
Ctrl+K: Show comment of selected target module.
ADVICE: Press F5 to switch to the comment editor.