Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 32)

Accessing target modules (basic functions)
24 · G&D DVICenter
How to cancel the automatic access to a target module:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F10 to open the Personal Profile menu.
3. Select the Default target entry and press Enter .
The Default target menu opens. The active target module is highlighted in the list field.
4. Press F8 to cancel the selection. The target module is no longer marked with an
arrow ().
5. Press F2 to save your changes.
Messages when accessing a target module
»No free route to target«
For every time a user module simultaneously accesses a target module connected to the
slave matrix switch, a data link is established from the master to the slave matrix switch.
In case all available data links are occupied, the message »No free route to target« is
displayed when you try to access the target module. As soon as a data link is availa-
ble, the desired connection can be established.
»No route to target known« or »Unknown route to target«
This message is shown when you try to access a target module connected to a slave
matrix switch to which no connection can be established.
Check if the slave matrix switch is switched on and properly connected to the mas-
ter matrix switch.
»Target not available«
This message is shown when the target module to which the target computer was
connected has been removed from the system.
Ask the administrator of the matrix system if the desired target computer has been
connected to another target module or if it has been removed from the system.
IMPORTANT: The number of possible data links to the slave matrix switch depends
on how many CPU ports of the master matrix switch are connected to the Console
ports of the slave matrix switch.