Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 41)

Switching the target modules automatically or manually
G&D DVICenter · 33
Configuring the scantime of the Autoscan function
By default, each target mdoule is accessed for five seconds. After that, the target
module is disconnected and the next target module is accessed.
Select a time span between 1 and 99 seconds to define how long the target module is
to be accessed.
How to change the scantime:
1. Press the
Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F10 to call the Personal Profile menu.
3. Move the cursor to the Scantime entry and enter a span between 1 and 99 seconds.
4. Press F2 to save your settings.
Auto scanning all active target modules (Autoskip)
The Autoskip function successively accesses any target module that is included into
the active scancode set and available to the user.
The connected computer must be active to carry out this function.
The Scantime setting (see page 33) enables you to define how long each target mod-
ule is to be accessed.
When accessing the target modules, the workplace name, the name of the currently
accessed target module, and a note regarding the Autoskip function are displayed.
NOTE: If the Autoskip function is active, the keyboard and mouse inputs are trans-
mitted to the currently accessed target module.
During the inputs, the Autoskip function stops and continues after you finished
your inputs.